TANDBERG Media Processing System MPS 200 - Manual (Page 44)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Dual Video Stream
The MCU supports DuoVideo TF , H.239 and BFCP.
On: Set to On to enable a Dual Video Stream protocol for this
conference. Both DuoVideo TF and H.239 or BFCP are sup-
ported in the same conference.
Off: When set to Off, Dual Video Stream will not be supported
in this conference.
Conference Selfview
On:
Set to On to enable Conference Selfview. The users will
see themself in the picture when more than one participant is
in the conference.
Off: Set to Off to disable Conference Selfview.
Telephone Indication
On:
Set to On to enable a Telephone Indicator to be displayed
when there are telephone (audio only) participants connected
to the conference. When the telephone participant is speaking
the indicator will be outlined.
Off: Set to Off to disable the Telephone Indicator to be dis-
played.
Speaker Indication
On:
Set to On to enable a Speaker Indicator, a coloured line,
to be displayed around the sub-picture that will indicate who is
the currently speaking participant.
Off: Set to Off to disable the coloured line to be displayed.
Lecture Mode
On:
Set to On to enable the Lecturer to be displayed in full
screen to the other participants.
The Lecturer is the participant which is assigned floor. •
The Lecturer will see a scan of all the participants in a full •
screen view or one of the supported sub-picture views. To
enable the scan of other sites the
CP Autoswitching must
be set.
Off: Set to Off to disable the Lecturer, the participant which is
assigned floor, to be view in full screen.
Create Only
Select Create Only to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Add Participants
Select Add Participants to add participants
or to manually dial a participant.
Cancel
Select Cancel to discard all changes and
return to the Conference Overview page.
Video Settings (3:5)
44
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Using
the MPS