TANDBERG Media Processing System MPS 200 - Manual (Page 28)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Restart the TANDBERG MPS
To activate changes to the Parameter Configuration
the MPS requires a restart.
Use • Arrow Left to step back to the main menu and
select Restart
Parameter Configuration
Press any key to open the main menu. •
Use • Arrow buttons to select from the sub-
menu and press the Confirm button.
 
Initial Configuration
LCD
Before using the TANDBERG MPS it requires
some basic configuration. This is done
through the Liquid Crystal Display (LCD) on
the front of the chassis.
Preparing the MPS
Follow the instructions in the Start-
ing the System section to prepare the
system for configuration.
Static Network Addresses
Follow the instructions, to the right, to con-
figure static network addresses and Ethernet
speed of the System Controller Board (SC)
and the Media Processing Board.
Access to the MPS
After configuring the IP-address of the System
Controller Board (and restart the MPS), you
may continue the configuration from the web
interface. You have access to the TANDBERG
MPS by entering the IP-address of the System
Controller Board in a standard Web-browser.
Enter Password
You will be asked to enter a password. The
Internet Explorer 7 requires a User Name to
be entered. Could be such as ‘admin’. The
default password for the TANDBERG MPS is
“TANDBERG”. The password is case sensitive.
Change Password
To change the password of the system, you
need to log into the Command Line Interface.
For information please see the TANDBERG
MPS API document supplied with the system
or on
www.tandberg.com .
Use Arrow buttons to select SC IP Config and
press the Confirm button.

Use Arrow buttons to select a line and set the
three addresses and the Ethernet speed. Use
Arrow Left to step back in the menu.
IP : Defines the static IP address of the System
Controller Board: Example <192.168.001.100>
SNM : Defines the static IP Subnet Mask for
the network: Example <255.255.255.000>
GW : Defines the static IP Gateway address:
Example <192.168.001.001>
IF Speed : Defines the Ethernet speed: <Auto/
10Half/10Full/100Half/100Full>
SC IP Config - Configuration of the System
Controller Board.
!
Parameter Config - Configuration of System
Controller Board(s) and Media Processing
Board(s).
Parameter Info - See the configuration of
the System Controller Board(s) and Media
Processing Board(s).
LCD Settings - Configuration of the LCD.
Restart - Restart the MPS

LCD buttons
Press Arrow Up to move up in the menu or to increase a digit (0 –> 9)
Press Arrow Down to move down in the menu or to decrease a digit (9 –> 0)
Press Arrow Left to step back in the menu or to move the next digit to the left
Press Arrow Right to step forward in the menu or to move the next digit to the right
Press Confirm button to confirm a selection
Parameter Config
Parameter Info
LCD Settings
Restart
SC IP Config
Media IP Config
IP <192.168.001.100>
SNM <255.255.255.000>
GW <192.168.001.001>
IF Speed <100Full>
Initial Configuration
System Controller Board - Parameter Configuration
28
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main Installation