Tasco Digital Trail Camera 119223C - Manual (Page 11)

11
area, press the MENU button, then step away from the camera. Move
straight back from the camera to find the length (depth) of the sensor
detection zone, and move left or right to check the width (edges) of the
detection zone (note that it becomes wider as you move farther back-see
below). When you no longer see the red PIR indicator flash as you move
around, you are past the limits of the coverage area. Reposition the
camera if necessary. When you finish testing the camera, press and hold
MENU to exit Menu mode.
3. Set the Camera
Make sure the camera’s power is turned on, and make sure a new or
empty SD card has been inserted, then leave the area-there is a 30 second
delay after power on before the first photo is taken. Batteries typically last
90 days or more, depending on how often the Cam is activated by events,
how often the flash fires, ambient temperature, etc.
4. Secure the Camera
A standard padlock may be used in the camera’s lock hole to secure it and
prevent theft.
CAMERA OPERATION (continued)