Tasco Digital Trail Camera 119223C - Manual (Page 7)

7
CAMERA SETUP
Open the Cam by pulling out on the two latches on the right side. Install
4 “C” cell batteries (flat base of all batteries contacting springs), and insert
an SD card (not included, use any capacity from 16MB to 8GB. Do not
substitute MMC cards.) in the slot to the right of the 5 buttons as indicated
on the slot cover (upside down, with the notched corner of the card on
the left and metal contacts of the card facing the back of the slot). Press
the card down until you hear it click into place. If the Cam is turned on
without a card in place, it may not turn off-reset it by pulling one of the
batteries out partway, insert a new or empty SD card, and put the battery
back in place. Only remove or insert cards with power off.
1. Setting the Date, Year and Time
If you are using the camera for the first time, you should set the date and
time so your photos will be “stamped” correctly.
Set Date and Year
Briefly press the MENU button-the first two digits of the year will •
flash, prompting you to enter the year.
Use the UP/DOWN buttons to set the current year (2010-2030), then
•
press OK. Set the month the same way, and press OK again.
Set the month the same way, and press OK again. The display will
•
then change to let you set the day, with only the last two digits
blinking.
Setup Icons- Display Guide
1. Date
2. Time
3. 4 Digit Display
4. Still Photo Mode /
Resolution
5. Video Mode
6. SD Card
6