Tekkeon ET2000 - Manual (Page 5)

3 USER GUIDE
Charging ezTalker mini
Before using ezTalker mini, you must charge the headset for approximately two hours. When fully
charged, the battery provides up to five hours of talk time and up to 120 hours of standby time.
To Charge the Headset
1. Remove the rubber plug that covers the charging jack on the upper
left side of the headset.
2. Plug the power adapter into the charging jack.
3. Plug the power adapter into a wall outlet. While the headset is
charging, the amber LED on the headset will remain on. When the
headset is fully charged, the amber LED will turn off.
4. Unplug the power adapter from the wall outlet and the headset.
5. Place the rubber plug in the charging jack.
BATTERY INDICATION: When the battery is low (less than 10% of capacity), the amber LED will
flash and you’ll hear a beep every 32 seconds.
Pairing ezTalker mini to Your Mobile Phone
Pairing is the process of linking the headset with your Bluetooth mobile phone. Before using
ezTalker mini with your mobile phone you must pair the devices. After this process is complete,
you can use the headset only with its paired mobile phone. To use ezTalker mini with a different
mobile phone, you must repeat the pairing process with the new mobile phone. In this case, the
headset will no longer work with the original mobile phone.
BEFORE YOU PAIR THE HEADSET, ENSURE THAT THE BATTERY IS FULLY CHARGED, AND REVIEW THE INSTRUCTIONS
IN YOUR MOBILE PHONE USER GUIDE FOR PAIRING YOUR MOBILE PHONE TO A BLUETOOTH HEADSET.
Figure 1.
Power adapter connected to
ezTalker mini.