Tekkeon ET2000 - Manual (Page 7)

5 USER GUIDE
To Replace the ezFit Earpiece
1. To remove the ezFit Earpiece, hold the plastic and gently pull toward you.
2. Snap the other ezFit Earpiece into place.
To Add the ezEarhook
1. Position to hole on the end of the ezEarhook over the stem on the rear of ezTalker and push to
snap the ezEarhook into place.
2. If the ezEarhook is positioned for your right ear, swivel the hook counter-clockwise
until the hook is to the right of the earpiece and rotate the top portion of the hook
to wear on your left ear. If the ezEarhook is positioned for your left ear, swivel the
hook clockwise until the hook is to the left of the earpiece and rotate the top
portion of the hook to wear on your right ear.
3. Mold the soft plastic on the ezEarhook as needed for a better fit.
To Remove the ezEarhook
1. Gently pull the ezEarhook away from the headset stem until it separates from the headset.
Powering ezTalker mini
To Turn On the Headset
Press and hold the TALK button approximately four seconds until the blue LED flashes or until you
hear the ON tone. The headset turns on and is placed in standby mode, ready to make and receive
calls. While the headset is on and in standby mode, the blue LED will flash at two-second intervals.
Figure 3.
ezEarhook
(positioned for
left ear)
Figure 2.
ezTalker mini with
ezFit Earpiece