Tekkeon MP1860A - Manual (Page 9)

7 USER GUIDE
Charging your iPad, iPhone or iPod Using the 30-Pin USB Cable
1. Insert the USB plug on the 30-pin cable into one of the output ports on TekCharge MP1860A.
2. Connect the 30-pin connector into the dock connector on your iPad, iPhone or iPod.
3. Slide the MP1860A power switch to ON to provide power through the USB port.
4. Turn on your iPad, iPhone, or iPod and use it as you would normally. While connected,
TekCharge MP1860A will power and/or charge your device.
Or
Leave your iPad, iPhone or iPod turned off and TekCharge MP1860A will charge the device
battery.
5. When finished, unplug the USB cable from TekCharge and your iPad, iPhone or iPod.
TIP: You can use the emergency flashlight while charging your iPad, iPhone or iPod.
NOTE: You can sync your iPad, iPhone or iPod while it is connected to an output port, and
TekCharge MP1860A is connected to your computer with a USB/Mini USB data cable (not provided).
Charging iPad using
the 30-pin USB cable.