Texas Instruments TI-86 - Manual (Page 244)

232
Chapter 17: Memory Management
17MEMORY.DOC TI-86, Chap17, US English Bob Fedorisko Revised: 02/13/01 2:37 PM Printed: 02/13/01 3:05 PM Page 232 of 4 17MEMORY.DOC TI-86, Chap17, US English Bob Fedorisko Revised: 02/13/01 2:37 PM Printed: 02/13/01 3:05 PM Page 232 of 4 17MEMORY.DOC TI-86, Chap17, US English Bob Fedorisko Revised: 02/13/01 2:37 PM Printed: 02/13/01 3:05 PM Page 232 of 4
Resetting the TI-86
The MEM RESET (Reset) Menu - ™ (
RAM DELET RESET TOL ClrEnt
ALL MEM DFLTS
ALL When confirmed, all data is cleared and memory is reset; both messages are displayed
MEM When confirmed, clears all stored data from memory; Mem Cleared is displayed
DFLTS When confirmed, resets all defaults; Defaults Set is displayed
When you select ALL , MEM , or DFLTS , a confirmation menu
is displayed.
♦ To confirm the selected reset, select YES (press )).
♦
To cancel the selected reset, select NO (press *).
ClrEnt (Clear Entry) - ™ *
The TI -86 retains as many previous entries as possible in
ENTRY , up to a capacity of 128 bytes.
To clear the ENTRY storage area of all entries, execute ClrEnt
on a blank line on the home screen (- ™ * b).
Before resetting all memory,
consider deleting selected
information to increase
memory capacity (page 231).
When you select and confirm
ALL
or DFLTS, the default
contrast is reset; to adjust it,
use
- $ or - #
(Chapter 1).