Texas Instruments TI-86 - Manual (Page 250)

238
Chapter 18: The TI -86 Communication Link
18LINK.DOC TI-86, Chap 18, US English Bob Fedorisko Revised: 02/13/01 2:40 PM Printed: 02/13/01 3:05 PM Page 238 of 10 18LINK.DOC TI-86, Chap 18, US English Bob Fedorisko Revised: 02/13/01 2:40 PM Printed: 02/13/01 3:05 PM Page 238 of 10 18LINK.DOC TI-86, Chap 18, US English Bob Fedorisko Revised: 02/13/01 2:40 PM Printed: 02/13/01 3:05 PM Page 238 of 10
When you select any LINK SEND menu item, except BCKUP
or WIND , each variable of the selected data type is listed in
alphanumeric order on a selection screen. The screen to
the right is the
SEND ALL screen (- o & *).
♦
The data type of each variable is specified.
♦
Small squares indicate that xStat , yStat , and Q2 are
selected to be sent.
♦
The selection cursor is next to Q4 .
To select a specific variable to be sent, use # and $ to move the selection cursor next to
the variable, and then select
SELCT (') from the selection screen menu.
♦
To select all variables of this type, select ALL+ from the selection screen menu (().
♦
To deselect all variables of this type, select ALL- from the selection screen menu ()).
To complete transmission of the selected variables, prepare the other unit to receive data
transmission (page 239), and then select
XMIT from the selection screen menu (&).
The SEND WIND (Window Variables) Screen
When you select WIND from the LINK SEND menu (- o
& / / (), the
SEND WIND screen is displayed.
Each SEND WIND screen item represents the window
variables, format settings, and any other graph-screen data
for that TI
-86 graphing mode and for ZRCL (user-created
zoom). The screen to the right shows that the graph screen
data for
Func and DifEq graphing modes are selected.
Func Select to send Func graphing mode window variable values and format settings