TravRoute Pocket PC 5 - Manual (Page 6)

- vii - - viii -
7. In-vehicle hardware setup
8. Adjust the speech volume
To hear CoPilot’s voice prompts, the volume on your Pocket PC must be
turned all the way up. In the Pocket PC Start menu, go to Settings and tap
on Sounds and Notifications. Under System Volume, move the slide
bar all the way to the right. Or use your Pocket PC’s keypad when CoPilot
is open: tap up until you reach the maximum volume.
If you installed the TTS (text to speech) voice option, you may also want to
turn on the “Amplify Speech Volume” option — tap the Tools menu
(if the menu isn’t visible, tap at the top or bottom of the screen), select
Options, and tap the Guidance tab.
WARNING: Never leave the GPS receiver in a closed vehicle that exceeds 60 o C.
(For complete instructions, see the GPS Receiver Guide that came with the product,
or tap Tutorial in the Welcome screen on your Pocket PC.)
First turn on your Pocket PC, then make sure that the GPS receiver is attached
and powered and your engine is running before using CoPilot.
If you have a CoPilot vent mount and in-vehicle power adapter:
1. With your engine running, attach the cable to the Pocket PC and insert it
into your vehicle’s cigarette lighter socket. Make sure it is firmly seated
(red light on).
2. Attach the vent mount clips to the vent in your vehicle, in a position that
will allow you to be comfortable as you view and operate CoPilot.
3. Slide the Pocket PC into the vent mount, and make sure it is turned on.
GPS Receiver setup:
Open CoPilot and tap the GPS button in the Welcome screen to set up your
GPS receiver. CoPilot will scan all COM Port and Baud Rate settings until it
finds your GPS receiver.
9. Enter an address
NOTE: There is no need to enter a starting point. CoPilot uses GPS
positioning to determine your location automatically.
If you choose to activate a region other than the region pre-installed on your
QuickStart storage card, you will be required to download the selected region
to your storage card using the Data Download Wizard from within the CoPilot
desktop application. Additionally, you will not be able to use the data region
that was pre-installed on your card.
1. In the Welcome screen,
tap Going To.
2. In the Going To screen, tap
Add Stop.
3. In the Select Stop screen,
tap Address.
4. Using the keyboard, enter
a postal code and tap
Next, or type the name of
a country — as you type,
the scroll list will move to
that country. Tap it on the
list, then tap Next
.
NOTE: For the United
Kingdom, postal codes
are entered in the City
screen (Step 5). The
country entry screen
won’t appear if map data
for only one country is
downloaded.
5. Type a city name or pick
one from the list and tap
Next.
6. Enter a house number
if you like (it’s optional),
then enter a street name.
As you type,
database matches will
appear below. If no exact
match is found, highlight
one of the
possible matches and
tap Next.
Step 1 Step 2
Step 3
Step 5 Step 6
Step 4