TechniSat EC 4004 - Manual (Page 19)

TechniSat EC 4004
19
5.2.3 Channel settings
New channels which are not part of the preprogrammation can be readily added.
As soon as you modify the channel settings, the table identification changes from "F" to "H".
MEM
Only when you have memorized the modifications by pressing • , "F" is re-displayed.
Important: Numerical entries only become valid, when the screen returns to channel display.
Only then are you allowed to make further entries. When repeatedly pressing the
same key, for example the sound channel key , you should not make long
breaks.
5.2.3.1 Video settings
> Pressing the key, the display shows the receive frequency in MHz (950 to 2050).
There are two ways to enter new receive frequencies :
> enter them directly with the numerical keys
> or pressg to increase or decrease the value
When holding the keys depressed, the frequency changes continuously, starting at 1 MHz
steps followed by 5 MHz increments, after 10 changes.
Improper entries via the ten-key keypad will be acknowledged by the error message "Err".
SAT
You can set the video level by pressing the key repeatedly. Satellites and their corre-
sponding satellite types are listed in chapter 6.1, satellite types.
MEM
Press the • key to memorize your settings and, if necessary, enter a new channel number.
5.2.3.2 PAL audio settings
Select the PAL channel whose audio settings you want to modify.
> press until the desired sound channel is displayed.
> Use the numerical keys or the keys to set the new audio frequency.
> To receive in stereo press , A/B
A/B
A/B
*EC 4004 ENGL. 14.12.1999 9:59 Uhr Seite 19