Teledex IP250DVoIP - Manual (Page 15)

Teledex IP250D User’s Guide SIP/MGCP
CONFIGURING THE IP250D
10
3.6.3 SNMP Settings
This sub-page is used for configuring the device’s SNMP server. Configure the SNMP
Trap Host IP address and community, the SNMP read and write community parameters,
and the SNMP System Description and System Object ID parameters. Press Save SNMP
Settings
to apply the new values. These settings will only take effect when the device is
rebooted.
3.7 DOWNLOAD CONFIGURATION
This page provides two options for downloading a new firmware application image
to the device. If you wish to download the new firmware image using TFTP, enter the
filename of the ROM image and enter the IP address of the TFTP server on which this
file resides. Press START TFTP DOWNLOAD to initiate the TFTP download process.
If the ROM image is stored on the same local machine you are using to access the
device’s web pages, you can choose to download the ROM file to the device using an
HTTP post. Enter the filename of the ROM image or press BROWSE to help locate the
file. Press START HTTP DOWNLOAD to initiate the HTTP download process. If the main
application is executing at the time, the device will automatically reboot itself into the
downloader mode and begin the download process. If the downloader application is
executing at the time, the download process will begin. The download status will be
displayed when the image download process is complete. Please refer to Section 6, The
Downloader Application for more details on the download process.
3.8 RESET CONFIGURATION
This page provides options for resetting the device. Select whether you wish to reset the
device and start executing the main (default) application, or whether you wish to reset
the device and start executing the internal downloader application. Press RESET to reset
the device.