Teledex IP250DVoIP - Manual (Page 21)

Teledex IP250D User’s Guide SIP/MGCP
USING THE IP250D
16
• If a call arrives on line 1 while a conversation is being conducted on line 2, the
conversation on line 2 may be terminated by hanging up the call. After the call on
line 2 has been terminated, the phone begins using the normal ring tone for the
call on line 1 rather than the half-second tone on the speaking device.
In addition to accommodating incoming calls on the second virtual line, the software
allows outgoing calls to be made on the second line. This can be done by placing the first
line on hold, and then dialing the destination number (using the keypad, speed dial, or
the directory.) Both lines may be placed on hold simultaneously. If both lines are on hold
and the HOLD key is pressed, the call that was first placed on hold will be the one that is
released.
4.9 MUTING A CALL
Press the MUTE key to mute the microphone of either the handset, headset, or speaker-
phone, depending on which is in use. A green LED indicates that the phone is in "mute"
mode. To remove mute, repress the MUTE key again.
4.10 TRANSFERRING A CALL
To transfer a call, press the XFER key, then dial the number to which the call is to be
transfered When either a ring or a dial tone is heard, the phone may be hung up to com-
plete the transfer.
4.11 REDIALING THE LAST NUMBER DIALED
The REDIAL key allows the last ten numbers dialed to be viewed. Press REDIAL and use
the SCROLL keys to see the last ten numbers dialed. Press the keys 0-9 on the keypad to
select the desired number. (Pressing the ‘0’ key will dial the tenth number on the list.)
4.12 FORWARDING ALL CALLS
Your calls may be forwarded to either an IP phone or standard analog or digital phone,
including wireless phones. To do this, place the phone off hook in either handset or
headset mode. Press the FWD key. Dial the number to which calls are to be forward.
To deactivate call forwarding, go off hook and press the FWD key. While the phone is in
the call forward state, the message FORWARDING TO: and the number to which calls are
to be forwarded is displayed on the LCD.