Topfield TF 5100 CI - Manual (Page 38)

32 Service Search
3. Choose your desired transponder at the Frequency op-
tion or input it with the numeric buttons.
4. Input the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5. Set the Polarization option to the polarization of your de-
sired transponder.
6. Specify the PIDs of your desired service at the PID menu
with the numeric buttons. PID (Packet Identifier) is a set
of numbers that identifies transport stream packets.
To search every service of a SMATV transponder, if the digi-
tal receiver is connected to a SMATV, perform the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to SMATV.
3. Choose your desired transponder at the Frequency op-
tion or input it with the numeric buttons.
4. Input the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5. Set the Polarization option to the polarization of your de-
sired transponder.
You can search pay services as well as free services. To search
only free services. set the FTA/Scrambled option to FTA only.
FTA means free service. To search only pay services, set it to
CAS only
. CAS means pay service. To search both free services
and pay services, set it to FTA + CAS.
To start service search, select the Start Search item; then ap-
pears a list box, in which found services will be listed. Press
the
✄
✂ ✁
OK button to save found services when it is completed.
To stop at any time, or to exit without saving, press the
✄
✂ ✁
EXIT
button.