Timex GlobalTrainer US QSG User Manual

Page 4

Advertising
background image

3

4

Appears when the chrono is running and a timer has been enabled.

Current time of Day

Solid: Heart rate monitor is communicating properly.

Blinking: Device is pairing or has received no useful data for 15 seconds.

Solid: Speed or cadence sensor is communicating properly.

Blinking: Device is pairing or has received no useful data for 15 seconds.

Solid: Power meter is communicating properly.

Blinking: Device is pairing or has received no useful data for 15 seconds.

Solid: GPS has a satellite fix.

Blinking: GPS is seeking a satellite fix. None: GPS cannot locate a satellite.

Charge Your Global Trainer

Bodylink

®

System Watch

Before you use the Global Trainer

watch for the first time, the lithium-ion

battery must be charged. A depleted battery takes approximately 2 1/2 to 3 1/2

hours to fully charge.

CAUTION: The Global Trainer

watch should only be charged within a tempera-

ture range of 32°F - 113°F (0°C - 45°C).

Charge Using the USB Cable

1. Insert the large USB-A plug on the download/charging clip into a USB port

on any powered computer.

2. Attach the download/charging clip to the back of the Global Trainer

watch.

3. Make sure the four contacts on the clip touch the four metal discs on the

back of the watch. Match the red dot on the watch with the red dot on the

connector for proper orientation.

DWN / STP / RST (q)

In a menu, press q to highlight the item below or to the right of the currently

selected one.

In PERFORMANCE or MULTISPORT Mode with the chronograph stopped and

reset, press q to display the previous view screen.

In PERFORMANCE Mode with the chronograph running, press q to stop (or

pause) the chronograph. If the chronograph is stopped (or paused), hold q to

reset the chronograph (follow the directions on the screen).

In MULTISPORT Mode, press q to transition to the next sport. Hold q to pause

the workout. If MULTISPORT Mode is paused, press q to reset the chronograph

(follow the directions on the screen).

START / SPLIT

Press START / SPLIT in PERFORMANCE or MULTISPORT mode to begin timing a

workout. Press it again when the chronograph is running to take a split and to

time laps individually.

Status Bar

The status bar appears at the bottom of all screens. It shows the battery

charge remaining, the current time, and status icons to give an at-a-glance

view of the Global Trainer

watch’s status.

Status Bar Display Icons

Shows the approximate charge of the battery. More dark segments

indicate a higher charge.

Appears when the chronograph is running

Appears when the alarm is set.

Advertising
This manual is related to the following products: