Timex GlobalTrainer US QSG - Manual (Page 8)

11 12
may take several minutes. For subsequent sessions, the GPS signal fix should
take 30 to 90 seconds. If a subsequent session takes longer than 2 minutes for
GPS signal fix, this message displays:
If you select YES, the GPS signal fix will go into full search mode, which may
take several minutes.
NOTE: The maximum time the chronograph will measure is 20 hours. If this
time is reached, you must save or reset the workout.
Take a Lap or Split
Press START/SPLIT when the chronograph is running to take a lap or split. Up to
three displays will appear in sequence.
NOTE: While the lap data is being displayed, the chrono has begun timing the
next lap.
9. Repeat from the beginning to change the number of fields or data in any of
the other view screens.
The explanation of each data field can be found in the USER GUIDE. See the
steps to Choose the Number of Fields and Select Performance Data in the
PERFORMANCE (Mode) View Screens section of those instructions.
To change the view screen name, and to change the activity associated with
each view screen, see the steps to Name the View Screen and to Configure
Calorie Expediture Settings in the PERFORMANCE Mode View Screens section
of the USER GUIDE.
Start a Workout
1. Press MODE until PERFORMANCE appears.
2. Press  or q to select a view screen.
3. Press START/SPLIT to start the chronograph and begin your workout.
NOTE: If the GPS is not fixed on a satellite, this message displays:
If you select NO, the chronograph will not start. Move into a position with a
clear view of the sky where the Global Trainer ™ watch can receive and fix onto
the GPS signals.
NOTE: The first time you wear the Global Trainer ™ watch, this GPS signal fix