Connecting to a tv – Toshiba SD-43HK User Manual
Page 7
CONNECTIONS
12
11
•
The signal of S-VIDEO OUT jack will output only when the function mode is selected to CD/DVD.
•
On the rear panel SCART cable is indicated as “AV OUT.”
Note
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE
selector of the center unit to RGB. You can get a better picture
quality by using Scart setting.
• If Scart (RGB Input) is not equipped for your TV, set RGB-
COMPOSITE selector to COMPOSITE.
Connecting to a TV
Depending on your TV and other equipment you wish to connect, there are various ways you could
connect the player. Use one of the connections described below.
Video connection (Good)
•
Connect the VIDEO OUT jack on the DVD Receiver to the video in jack on the TV using
the video cable supplied (V).
S-Video connection (Better)
•
Connect the S-VIDEO OUT jack on the DVD Receiver to the S-Video in jack on the TV
using the optional S-Video cable (S).
Component Video (Color Stream®) connection (Best)
•
Connect the COMPONENT VIDEO OUT jacks on the DVD Receiver to the corresponding
in jacks on the TV using an optional Y Pb Pr cable (C).
Scart connection (Best)
If you television is equipped with an SCART input, connect an Scart Jack (not supplied)
from the AV OUT jack on the back panel of the system to the SCART IN jack on your
television.
Y
Rear of TV
SCART
IN
The video output of this unit may vary depending on the TV video format (NTSC or PAL) in use.
•
In PAL mode: Video signals can be output through RGB (SCART) and Composite Video only.
•
In NTSC mode: Video signals can be output through Component Video (Y/Pb/Pr), Composite Video,
and S-Video.
Please turn off the Power of your TV, DVD receiver and other equipment before doing
any connections. Set the volume to low initially.
Note