Teledyne 2103 - Manual (Page 26)

2103 Modem Module
Section 3 2103c Cellular Modem Module
3-4
5. On the next screen, locate your service provider’s name in
the left column and in Flowlink program the correct pager
service number (Phone Number) and parameters (Comm:
7E1 or 8N1) under “Phone number list”. (See Figure 3-5.)
Figure 3-5 TAP Service Parameters
6. Enter your password(s), if applicable.
7. At the bottom of “Phone number list”, in the form field labeled
Message,
type the outgoing text message (maximum of 32
characters).
8. Under “Alarm condition”, select the desired alarm parame-
ter from the drop-down list, then define the alarm condi-
tions.
For detailed information about alarm programming, consult
Flowlink’s Help files.
Note
When any communication connector is not in use, it should
always be capped. The cap will seal the connector to prevent
corrosion, prevent moisture from entering the unit, and improve
communications.
TAP service
number &
parameter
values