TRENDnet TEW-509UB - Manual (Page 32)

26
C ONFIGURING WPA-PSK & WPA2-PSK (TO BE SUPPORTED) Refer to the
following to configure WPA-PSK & WPA2-PSK.
1. Click the drop-down arrow at Security Mode and choose WPA-PSK or WPA2-PSK.
2. Click the drop-down arrow at Encryption Method and choose TKIP or AES. (Most access
points use TKIP for WPA-PSK & WPA2-PSK.)
3. At PSK Pass Phrase enter the same pass phrase used to configure the WPA-PSK or
WPA2-PSK on your access point.
C
ONFIGURING 802.1 X
You need to know if your access point supports 802.1x and then apply the configuration here.
1. Choose the EAP method under Authentication protocol.
2. Options for User Information depend on the EAP method chosen.
C ONFIGURING 802.1 X – PEAP
Refer to the following to configure PEAP.