Tyco Electronics PL0349 - Manual (Page 9)

8 Port Ethernet Smart Switch With Fibre Uplink
Tyco Electronics Page 9
This screen enables
the port speed and
duplex mode to be
controlled.
The default is auto-
negotiation which is
the best method for
most new networks.
However, some
legacy systems may
need to use fixed
duplex and speeds,
so these can be
applied on the switch
using this menu.
Select the option 1..5
to change port
settings or select 6 to
return to the main
menu.
Figure 6 - Port Configuration - 2
Simple port based VLANs can be created by selecting option 2
from the entry menu. There are 2 steps to create VLANs. First
draw a map that shows a matrix of ports and VLANs.
Then select the port
and the required
VLAN ID (1..7). To
add the port to the
VLAN, enter option 1
and then enter option
3 to save the setting.
Repeat this for all
required VLAN and
port combinations.
Note that the switch
resets each time the
VLAN state is viewed.
This is normal.
Figure 7 - Port VLAN Configuration
Figure 8 - VLAN Configuration