Trilogy Touch Technology Trilogy Touch Monitor - Manual (Page 5)

6
Additional information about the On-Screen-Display
The OSD disappears (times-out) several seconds after you stop pressing the buttons while performing
an adjustment. This function can be adjusted up to 60 seconds allowing the user more time. This
adjustment is made in the “Settings” submenu.
Any changes made are automatically saved in the Touch Monitor memory when the OSD disappears.
Turning off the power should be avoided while using the OSD, as this may not allow changes to be
saved.
Adjustments for clock, phase and position s are saved for each signal timing or screen resolution.
Except for these adjustments, all other adjustments have only one setting that applies to all signal
timing.
The submenu color will change from white to pink when the function is selected.
You can skip the OSD menu and display commonly used adjustment scales directly by using the
following button operations (refer to previous diagram for button locations):
Brightness Press the Brightness Button (3) when the Menu is not displayed.
Contrast: Press the Contrast Button (2) when the Menu is not displayed.
Auto Setting: Press the Auto Button (5) when the Menu is not displayed.
The Auto Adjust process may take as much as 10 consecutive seconds. The display image will make
noticeable changes as the Auto Adjust function completes.
Self-Test Check:
This product provides a self-test ability, through which you can check whether the LCD monitor
functions are working properly.
If your LCD monitor is properly connected, but there is no image showing and the power indicator light
on the Touch Monitor displays orange , please follow the steps below:
1. Turn off both the computer and LCD monitor.
2. Unplug the video signal connector from the back of the computer.
3. Turn the LCD monitor on.
4. The monitor should display “No Signal Input” on the screen and the power LED indicator should be
orange. If no display is observed, there may be a problem with the Touch Monitor.
5. Turn off the LCD monitor and reconnect the signal cable. Then turn the computer and LCD monitor
on. As the computer boots, there should be a video display and the power LED should now be
green.
If the LED of the monitor is an orange color after completing the steps above, please check
your VGA card and computer system.
7
Menu Table
Primary
Directory
Secondary
Directory Description
Image Brightness Adjust the brightness of the screen.
Contrast Adjust the contrast of the image.
Clock Adjust the clock pulse of the image.
Phase Adjust the focus of the image.
H. Position Move the image left and right on the screen.
V. Position Move the image up and down on the screen.
Sharpness Adjust the picture sharpness of lower resolutions.
Audio Volume Adjust the volume of the audio.
Mute Set the audio mute to be on or off
Color 9300K Set the color temp. to 9300K white color.
7500K Set the color temp. to 7500K white color.
6500K Set the color temp. to 6500K white color.
User/Red
User/Green
User/Blue
Adjust red/green/blue gain.
Language English
Français
Italiano
Deutsch
Español
Settings OSD Timeout
OSD Position
Select the OSD language.
Adjust OSD display time setting.
Move OSD display position to any one of the following 5
positions within the overall screen.
Auto Setting Set up to adjust clock, phase and positions automatically.
Recall Restore to factory settings
Input
Source Analog
Select Analog input source:
3
1
5
2
4