Trilogy Touch Technology Trilogy Touch Monitor - Manual (Page 6)

8
FOR YOUR SAFETY
W ARNING
ALWAYS OPERATE UNDER KNOWN POWER SUPPLY
• Usage of incorrect voltage will cause malfunctions and may cause fire or electric shock.
PROTECT AND CORRECTLY USE THE SIGNAL CABLES
• Do not pull or bend the power cable and signal cable or place the monitor or any heavy
objects on the cables. If the cables are damaged, they may cause fire or electric shock.
IMMEDIATELY STOP OPERATING THE MONITOR WHEN YOU DETECT ANY
ABNORMAL OCCURRENCES
• If you notice any abnormal phenomenon such as strange noise, smoke or smells, unplug the
monitor and contact your dealer or the nearest service center immediately.
DO NOT REMOVE THE CABINET
• Removing the cabinet may expose you to the danger of fire or electric shock. Opening the
product will void the warranty.
DO NOT PUT ANY FOREIGN OBJECT INSIDE THE MONITOR
• Modification of this product may result in improper operation as well as voiding the warranty.
DO NOT USE THE MONITOR NEAR WATER
• Operating the monitor in close proximity to water where the water may enter the device may
cause fire or electric shock.
BAD WEATHER CONDITIONS
• It is advisable not to operate the monitor during heavy thunderstorms as intermittent breaks in
power may cause malfunctions. Do not touch the plug under these circumstances as it may
cause electric shock.
C AUTION
DISCONNECT CABLES WHEN MOVING THE MONITOR
• When moving the monitor, always turn off th e power, unplug the monitor, and disconnect the
signal cables.
DO NOT TOUCH THE ELECTRICAL CONNECTIONS WITH WET HANDS
• Pulling or inserting the plug with wet hands may cause electric shock.
HOLD THE PLUG WHEN DISCONNECTING
• To disconnect the power cable or signal cables, always pull the cables by the plug. Never pull
on the cable as this may cause fire or electric shock.
O THER C ONSIDERATIONS
Ergonomics Recommendations
Do not operate the monitor in a dark room or against a bright background. For optimal viewi ng comfort,
the monitor should be just below eye level and 30-60 cm (16-24 inches) away from your eyes. When
using the monitor over a prolonged period of time, a ten-minute-break per hour is recommended.
9
SPECIAL NOTES ON LCD TOUCH MONITORS
The following are normal with LCD Touch Monitors and do not indicate a problem.
l When the LCD Touch Monitor is first powered on, the picture may not fit in the display area. This
is because of the type of computer graphics system that is used. In such case, adjust the picture
position to a desired image (See Operating the Monitor).
l The screen may flicker during initial use. Turn off the power and then turn it on again the
flickering should disappear.
l Users may notice some uneven brightness on the screen depending on the desktop resolution
they use. It is normal for LCD Touch Monitors to show uneven brightness.
l Due to the nature of the LCD displays, images displayed on the screen for long periods of time may
still appear after the screen content has been changed. This phenomenon can be corrected, over
time, by switching display content or leaving the monitor off for a number of hours.
l If the screen becomes dark, flickers, or does not light-up, contact your dealer or the nearest
service center for a backlight replacement. Do not attempt to replace it yourself.
Cleaning
W ARNING
l If you dropped any material or liquid such as water onto the monitor when cleaning, unplug the
power cable immediately and contact your dealer or the nearest service center. Always make
sure your hands are dry when unplugging the power cable.
C AUTION
l For safety reasons, turn -off the power switch and unplug the monitor before cleaning.
l Do not scratch or rub the screen with a hard object.
l Never use any of the following solvents on the LCD Touch Monitor. Such harsh chemicals may
cause damage to the cabinet and the touch sensor.
Thinner Spray-type cleaner, Benzene, Wax, Abrasive cleaner, Acid or Alkaline solvent
Cabinet
l Remove dirt with a lightly moistened cloth and a mild solvent detergent. Then wipe the cabinet
with a soft dry cloth.
DISPLAY AREA (TOUCH SENSOR)
l Periodic cleaning with a soft dry cloth is recommended. Non-abrasive household window-type
cleaners are recommended.
l Do not use tissue to clean the display area. It may scratch or dull the LCD screen.
Power Management
This LCD Touch Monitor complies with the VESA DPMS (version 1.0p) power management specification.
DPMS provides four types of power saving modes by detecting the horizontal or vertical sync signal. As
well, the computer graphic card also needs to be DPMS compliant to utilize these modes.
Item DPMS Mode Display
Power
LED
Power
Consumption
Recovery
Time
H-sync V-sync
1 On Normal Green Normal --- On On
2 Stand By No Display Amber 5 W 3 sec < 10 KHz On
3 Suspend No Display Amber 5 W 3 sec On < 10 Hz
4 Off No Display Amber 5 W 3 sec < 10 KHz < 10 Hz