Thecus Technology Thecus N199 - Manual (Page 16)

First Time Setup
Once the hardware is installed, physically connected to your network, and
powered on, you can now configure the Thecus N199 so that it is accessible to
your network users. Follow the steps below for initial software setup.
Step 1: Initial Login
Make sure your network is connected to the Internet and access the N199 Login
webpage:
1. Type in the default IP address http://192.168.1.100 in your browser’s
address line. If you have changed the N199’s IP address, type this in
instead.
To access any IP address, your computer must be configured with the correct IP
settings. The IP address should be 192.168.1.x, where x is a number between 1 and
254.
NOTE
2. The Login screen appears.
3. To gain initial access to the system type in the factory default
administrator user name and password, which are as follows:
User Name: admin
Password:
admin
4. Press Login.
5. The About screen from the Status menu appears showing product
information.
Step 2: System Check and Configuration
Once logged in, you are greeted with the Web Administration Interface, where
you can check the N199’s status, as well as configure its operating parameters.
1. In the Status menu, choose the System item to go to the System
Status screen. Check that the basic system information such as CPU
loading and Fan RPM are all OK.
2. In the Status menu, choose the Info item to go to the System
Information screen. Change the System Description to describe your
system and press Apply. This information appears on the Login page.
3. In the System menu, choose the Administrator Password item. The
screen that appears lets you change the administrator password for the
system. Press Apply to confirm your settings.
4. In the System menu, choose the Time item and the Time screen appears.
Set the date, time and time zone and press Apply.
Step 3: Configure Network Settings
After setting the N199’s basic configuration options, the next step is to configure
its network settings.
1. In the Network menu, choose the LAN item and the Network
Configuration screen appears.
16