Raid auto-rebuild, Remote administration, Part i - setup a dyndns account – Thecus Technology Thecus N199 User Manual

Page 79: Part ii - enable ddns on the router

Advertising
background image

RAID Auto-Rebuild

When using RAID 1 on the N199, you can use the auto-rebuild function when an
error is detected.

1. When a hard disk fails the system beeps and/or an email notification is

sent to specified receivers.

2. Check the hard disk LEDs to see which disk has failed.

3. Follow the steps mentioned above to replace the failed hard disk.

4. The system automatically recognizes the new hard disk and starts the

auto-rebuild sequence to resume its status before the hard disk crash.

Remote Administration

You can set up your N199 for remote administration. With remote administration,

you can access your N199 over the Internet, even if your N199 is behind a router.
This is especially useful if you are traveling and suddenly need a file from your

N199.

Setting up remote administration is a three-part process, and will require the
following equipment:

Thecus N199 NAS device

Cable/DSL Router with Dynamic DNS support

Home PC

Internet Connection

NOTE

Router setup will differ slightly depending on router used. For this example, we will

use the Asus WL500g because it has support for Dynamic DNS. Contact your router

hardware vendor for setup help.


Part I - Setup a DynDNS Account

1. Go to http://www.dyndns.org from your home PC.
2. Click on the Sign Up Now link.
3. Check the Check boxes, select a user name (i.e.: N199), enter your email

address (i.e.: [email protected]), check Enable Wildcard, and create a
password (i.e.: xxxx).

4. Wait for an email from www.dyndns.org.
5. Open the email and click on the link to activate your account

Part II - Enable DDNS on the Router

1. Go to the router setup screen and select IP Config > Miscellaneous

DDNS Setting from your Home PC.

2. Click on Yes for Enable the DDNS Client?
3. Select www.dyndns.org.
4. Go to router setup screen, and enter the following information:

a. User Name or E-mail Address: [email protected]
b. Password or DDNS Key: xxxx

c. Host Name: www.N199.dyndns.org
d. Enable wildcard? Select Yes

e. Update Manually: Click Update


79

Advertising