TOYOTA 5613 - Manual (Page 14)

14 ‘05 - ‘06 Tacoma (W/ O.E. Hitch) - 3” Kit 5613
3. Cab driver side
a. Repeat previous steps on driver side of cab.
b. Set cab-to-bed spacing according to previous
measurement.
c. Remove front core support cab mount kit bolts
(3/8” x 8”) and apply a few drops of kit Loctite®
to threads. Install kit bolts, factory captive wash-
ers, factory lower washers and kit nuts (3/8”
Nylock). Tighten kit bolts to 55 ft. lbs.
d. Remove mid cab mount kit bolts (M12-1.75 x
200mm) and apply a few drops of kit Loctite® to
threads. Install kit bolts, factory captive wash-
ers, factory lower washers and kit nuts (12mm
Nylock). Tighten kit bolts to 55 ft. lbs.
Kit Bolt
(3/8” x 8”),
Kit Nut
(3/8” Nylock),
Factory Captive
Washer & Lower
Washer
Front Cab Mount
Mid Cab Mount
Kit Bolt
(M12-1.75 x 200mm),
Kit Nut
(12mm Nylock),
Factory Captive
Washer & Lower
Washer
e. Remove rear cab mount kit bolts (M12-1.25 x
210mm) and apply a few drops of kit Loctite® to
threads. Install kit bolts, factory captive wash-
ers, factory lower washers and factory nuts.
Tighten kit bolts to 55 ft. lbs.
Bed
1. Lift bed
a. Loosen, but DO NOT REMOVE, bed mounting
bolts on driver side.
NOTE
The number of bed mounting bolts may vary with the
length of the bed.
Rear Cab Mount
Kit Bolt
(M12-1.25 x 210mm),
Factory Captive
Washer, Lower
Washer & Nut
Loosen Bolts
At These Mounts
Bolts