TOYOTA 5613 - Manual (Page 28)

28 ‘05 - ‘06 Tacoma (W/ O.E. Hitch) - 3” Kit 5613
9. 4 cyl. models: Power steering requires no modifica-
tion.
10. 6 cyl. models: AC Line
a. Install rubber isolator to body.
b. Install AC line and clamp onto rubber isolator
with nut.
11. 4 cyl. models: AC Line
a. Install kit bracket (3” Z-shaped) to passenger
side AC line bracket with bolt.
b. Install AC line to bottom of kit bracket (3” Z-
shaped) with kit bolt (1/4” x 1”), two kit washers
(1/4” SAE) and kit nut (1/4” Nylock).
c. Install kit bracket (3” w/ stud) to rubber isolator
and passenger side AC line bracket with nut.
AC Line
Nut
Rubber
Isolator
Clamp
Install
Kit Bracket
(3” Z-
Shaped)
Here
AC Line
Bracket
Nut
AC Line
Install Kit Bracket
(3” W/ Stud) Here
Rubber
Isolator
AC Line
Bracket
d. Install AC line to kit bracket (3” w/ stud) with kit
washer (1/4” SAE) and kit nut (1/4” Nylock).
12. 6 cyl. models: Install airbox cover to engine with
two clips. Tighten clamp.
13. 4 cyl. models: Install air hose to engine with two
clamps.
Front of Vehicle
1. Front bumper
a. Apply a small amount of kit Loctite® to six fac-
tory studs and install kit brackets (front bumper)
to frame with six factory nuts.
Clamp
Clips
Airbox Cover
Clamps
Air Hose
Kit Bracket
(Front
Bumper)
Factory
Studs & Nuts