Toro GROUNDSMASTER 345 - Manual (Page 83)

TORO GM 345/325-D Cutting Units
Notes
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
81
Review Questions
1. Bearings and spacers should be replaced as a
set
a. True
b. False
2. The drive belt engagement spring should be
adjusted to a length of:
a. 2 1/4 inches
b. 3 3/16 inches
c. 1 1/2 inches
d. 4
inches
3. The cutting unit raise/lower lever should be in
the neutral position when mowing
a. True
b. False
4. Balancing the blade after sharpening is not
necessary.
a. True
b. False
5. The small spacer ring fits in a groove in the
spindle shaft.
a. True
b. False
6. The PTO drive belt alignment is not adjustable
a. True
b. False