Teac DVD Receiver DR-H300 - Manual (Page 9)

9
ENGLISH
Component video output terminals
Use commercially available component video cables to
connect the unit to the component video inputs of a suitably
equipped television or monitor to enjoy a high-quality
picture. Use these terminals in preference to S-Video or
composite video connections.
< If the component video terminals are connected to a
television with progressive scan capabilities, the output can
be set to match this (see page 35).
< Note that these terminals cannot be connected to high
definition component terminals.
S-Video output terminal
Use a commercially available S-Video cable to connect the
unit to the S-Video input of a suitably equipped television or
monitor. Use this connection in preference to a composite
video connection.
Composite video output terminal
Use a commercially available RCA (pin) video cable to
connect the unit to the composite video connector of a
television or monitor. Use this connection only if no other
video connection method is available.
D
C
B < Adjust the video aspect ratio to match that of the television
(see page 33) .
< This unit adopts analog copy protection features. If the unit
is connected to a TV through a VCR (video cassette
recorder), the resulting playback may be affected. Connect
the unit directly to the television.
< In all cases, use the highest quality cables for the best
possible picture.
< Select proper setting in the Video Output setup (see page
35).
HDMI video/audio output terminal
Use a commercially available HDMI cable to connect the unit
to a HDMI compatible television or monitor.
HDMI video output formats
480p (NTSC) or 576p (PAL)
720p
1080i
< See page 36 for further details on HDMI video output
formats.
< If the television or monitor is equipped only with a DVI
terminal, a suitable adaptor cable or adaptors should be
used. Note that the television connected in this way must be
HDCP compatible.
Also note that this connection outputs no sound.
< Make sure that you read and understand the documentation
provided with the HDMI component, as well as this unit’s
documentation.
To output audio from the HDMI terminal
If the connected HDMI component is capable of inputting
HDMI audio, digital audio can be output from the HDMI
terminal.
< Select “ALL” or “PCM only” in the SPDIF setup (see page
34).
< To enjoy the digital surround audio from DVD-Video discs,
connect the HDMI terminal to a surround amplifier and set
the SPDIF Setup to “ALL” (see page 34).
A