Tributaries T200 - Manual (Page 6)

The Tributaries T200 Power Manager is designed for audio/video & home theater systems requiring a single
solution surge suppressor as well as an effective AC line filtering device, all at a reasonable price. Featuring
13 outlets, 12 on the rear panel and 1 convenience outlet on the front panel, the T200 provides individual
AC outlet pairs for Analog electronics, Digital electronics and High Current power amplifiers.
The Tributaries T200 also features 2 USB outlets, one on the front panel and one on the rear panel.
AC LINE FILTERING and CONDITIONING
Tributaries T200 provides independent AC line filtering and conditioning for the (2) ANALOG, (8) DIGITAL
and (2) HIGH CURRENT outlets. This greatly reduces the noise generated from one component from
adversely effecting another.
AC LINE SURGE SUPPRESSION
The Tributaries T200 is designed with state of the art surge suppression electronics. In the extremely rare
event that this system fails, the PROTECTED LED on the front panel will not illuminate.
RF INPUT SURGE SUPPRESSION
Surge suppressed RF inputs and outputs for Cable TV, Satellite Receivers, and RF Antenna Systems are
provided. The RF inputs have the required bandwidth to pass satellite and cable or standard terrestrial TV
signals without loss.
PHONE / DATA LINE SURGE SUPPRESSION
Surge suppression for a phone and/or data input is also provided. Located on the rear panel, the RJ45 IN
jack can be connected to an RJ11 phone plug or an RJ45 data plug. There are (2) OUT jacks, (1) RJ45 and
(1) RJ11, providing surge suppression for (1) phone line in and (2) phone lines out or (1) data line in and (1)
data line out.
13 OUTLETS
On the rear panel, the (4) DIGITAL “Always-on” outlets (2 pair) are primarily designed for connecting Cable
TV set top boxes, satellite receivers and any device that is normally powered-on 24/7, (2) “Switched” outlets
(1 pair) – for components that are normally turned off after use and (2) outlets (1 pair) that are controlled
by a rear panel switch that can be set for “Always-on” or “Switched”. The (2) ANALOG “Switched” outlets
(1 pair) on the rear panel are designed for a/v equipment that is not microprocessor controlled or those
that are normally turned off when not being used. One pair of High Current “Switched” outlets on the rear
panel with a 5 second turn-on delay is provided for power amplifiers, receivers or integrated amplifiers.
There is (1) ALWAYS-ON unfiltered convenience outlet located on the front panel.
IMPORTANT NOTE
Designed for any 120VAC device, the front panel Convenience Outlet does not have line filtering.
1800 WATT / 15 AMPERE RATING
Tributaries T200 Power Manager is designed to provide a maximum of 1800W (120V@15A) of clean, filtered
and surge protected power to your audio and video components.
UNDER VOLTAGE and OVER VOLTAGE PROTECTION
Voltage surges and “brown-outs” can be damaging to electronic components. To protect your valuable
components, the T200 is engineered with a microprocessor circuit that is designed to protect against over
voltage and under voltage conditions. If the incoming voltage exceeds 135 volts, the T200 will shut down
5
InTroduCTIon and produCT overvIew
feaTures and TeChnologIes
!
E
NGLISH