Tributaries T200 - Manual (Page 8)

DIGITAL VOLTMETER
A digital voltage reading meter is provided on the front panel to indicate the voltage of the incoming AC
line. The meter’s blue LEDs illuminate when the unit is connected to a live main. The illumination may be
changed using the front panel DIMMER control.
DIGITAL AMMETER
A digital current reading meter is provided on the front panel to indicate the amount of current being
drawn from the AC line. The meter’s blue LEDs illuminate when the unit is connected to a live main. The
illumination may be changed using the front panel DIMMER control.
InsTallaTIon overvIew
The following is an overview for installing your Power Manager product.
Unpack all of the contents of the T200 carton. •
Plan your system and lay out all of the equipment that will be connected to the T200. •
Place the T200 in the location where it will be used, being sure to follow both the safety precautions •
listed in the front of this manual and the placement recommendations (see below). DO NOT plug the
unit in yet.
Plug each of the components into the T200. You may want to make a note on paper listing the •
components that are connected to each outlet.
Connect any devices with coaxial outputs to the F-connectors. •
Attach the phone / data line to the RJ-45 IN jack. •
With all of the attached components in the OFF position, plug the T200 into the wall. •
With the T200 OFF, attach remote triggering cables (if applicable). •
Test for proper operation. •
(1) Tributaries T200
(1) Installation & Operation Guide
(1) 12” Gooseneck Light w/USB connector
(1) 6ft phone cable
(1) 6ft RF cable
Think about which components need to work together, and place them in close proximity to one another.
Be aware of those products that generate the most heat and understand that excessive heat adversely
effects your components. Place them accordingly - allowing sufficient ventilations. You may also want
to consider putting frequently handled components in the most convenient locations. Decisions about
triggering options for your T200 will depend on many factors including the type of components in the
system and whether they are self-controlled or part of a multi-room or whole-house system. By carefully
planning the system’s architecture in advance, your T200 can be integrated into any configuration you
choose.
All components in a system must be connected to a Power Manager in order for the system to be protected
from electrical disturbances and to achieve maximum noise and AC line conditioning benefits. This includes
AC power cables, coaxial connections, and telephone and/or data cables. Failure to do this will degrade
system performance and leave it vulnerable to electrical damage.
PLACEMENT
It is recommended that the T200 be placed in the same location as your other audio/video components so
it can be easily reached when manually operating the other controls in the system. There should be a clear
line of sight between the operator and the unit to allow easy user feedback of system status. The T200
should be placed on a flat, stable shelf or platform.
7
paCkage ConTenTs
plannIng your sysTem
E
NGLISH