Thermador KBULT3655E - Manual (Page 12)

12
Side Trim
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add ¹⁄₃₂" (0.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than ³⁄₈" (9.5 mm) thick, route the front
edge to allow the side panel to fit into the trim.
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a
³⁄₈"
(9.5 mm) board to hold the panel in the cabinet side trim.
INSTALLATION REQUIREMENTS
To o l s a n d Pa r t s
IMPORTANT:
■ Installer: Leave Installation Instructions with the homeowner.
■ Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector’s use.
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts needed:
■ #8 x 3" (7.6 cm) or longer wood screws (6)
■ 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board (1 or 2)
■ Make custom or overlay panels or consult a qualified
cabinetmaker or carpenter to make the panels. See “Design
Specifications.”
■ If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
¹⁄₄" (6.35 mm) compression fitting.
³⁄₁₆
"
(4.5 mm)
³⁄₈
"
(9.7 mm)
¹⁄₁₆
"
(1.5 mm)
¹⁄₈
"
(3.2 mm)
A
A
■ Hand drill or electric drill
(properly grounded)
■ Drill bits
■ Adjustable wrenches (2)
■ Phillips screwdriver
■ Small level
■ Appliance dolly
■ T27 Torx ®† screwdriver
■
¹¹⁄₃₂" nut driver
■
³⁄₈" and ¹⁄₂" open-end
wrenches
■
⁵⁄₃₂" Allen wrench
■
⁵⁄₁₆" socket wrench
■ Tape measure
†®TORX is a registered trademark of Textron Innovations Inc.