Warning – Thermador KBULT3655E User Manual

Page 18

Advertising
background image

18

4. A

¹⁄₄" x ¹⁄₄" (6.35 mm to 6.35 mm) coupling is needed in order

to connect the water tubing to an existing household water
line. Thread the provided nut onto the coupling on the end of
the copper tubing.

5. Turn shutoff valve ON.

6. Check for leaks. Tighten any nuts or connections (including

connections at the valve) that leak.

7. Plug in the refrigerator or reconnect power.

8. Flush the water system. See “Water System Preparation.”

NOTE: Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to
completely fill ice container.

P l u g i n R e f r i g e ra t o r

1. Set control switch at top of cabinet to the OFF position.

2. Plug into a grounded 3 prong outlet.

M ove R e f r i g e ra t o r t o F i n a l

L o c a t i o n

IMPORTANT: To avoid floor damage, make sure levelers are
raised (not touching floor) and refrigerator is on rollers before
moving.

1. Place top of cardboard carton or plywood under refrigerator.

Remove dolly.

2. Do not remove protective film or cover.

3. Move the refrigerator straight back and evenly into the

opening. Be sure that the refrigerator side trims are not
interfering with the door opening. Also, be sure that the water
tubing is not kinked and the power supply cord is on top of
the refrigerator.

L owe r L eve l i n g L e g s

NOTE: All four leveling legs must contact the floor to support and
stabilize the full weight of refrigerator. Rollers are for moving
refrigerator and not for permanent support.

Use a

⁵⁄₁₆" socket wrench to turn the leveling bolts clockwise to

lower the 4 leveling legs until refrigerator weight is supported by
leveling legs. The rollers should be off the floor. To avoid cabinet
damage, do not apply more than 50 inch-pounds (58 cm - kg) of
torque to the leveling legs.

A. Water tubing
B. Nut

C. Bulb
D. Coupling (purchased)

E. Ferrule (purchased)
F. Nut (purchased)

G. Household water line (as

connected in previous section)

A

B

C

D

E

F

G

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

A. Rear leveling legs
B. Front leveling legs

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not
completely installed.

Keep doors taped closed until refrigerator is
completely installed.

Use two or more people to move and install
refrigerator.

Failure to do so can result in death or serious injury.

A

B

A
B

Advertising
This manual is related to the following products: