THB Bury Bluetooth Hands-Free Car Kit CC 9060 - Manual (Page 14)

24
Operating guidelines
25
22. Settings
In this menu point, you can configure the HFK through five further
submenus.
22.1 Bluetooth
Here among other things you can determine if the HFK should auto-
matically make a connection with your mobile phone via Bluetooth
® . In
addition you can delete the individual mobile phones or also the entire
list of the paired mobile phones and change the PIN code (standard
1234). It is possible to set one mobile phone as default. The device will
automaticly search first for the default phone and then search for other
phones.
22.2 Voice Dial
In this submenu you can carry out the following settings.
Activating or deactivating the audio feedback: If you activate the
audio feedback, during the touch screen operation you receive voice
support (e.g. the phonebook entries are read aloud to you). Your selec-
tion is shown through an information field
`ADDITIONAL HELP OFF´: This means that the HFK will only read
aloud the most essential commands and confirmations. This setting is
recommended if you are well acquainted with the HFK, your selection
is shown to you through an information field.
Redial
18. Redial
The number which was last selected can be selected once again
19. Call list
Here in a chronologic sequence all calls are listed which have been
made, missed or accepted.
You can have the telephone number read to you and if you want call
back. The navigation within the lists is carried out analogue to that of
the phonebook.
20. Messages
Received text messages are shown on the display and read aloud to
you. Up to 100 text messages can be stored. Both messages from the
SIM card as well as from the telephone are read aloud. It is suggested
that you regularly delete messages in order to ensure that you always
are shown the newest text messages on the display. In case you cannot
read all text messages (an information field is faded in) try it again la-
ter. You can also jump directly to a message shown by activating the
entry number. E.g.: `SELECT ENTRY THREE´.
If you want you can call the sender back.
Note:
With this voice command (is not shown on the display) you
can immediately have a new text message read aloud with
active voice control.
21. Dial Joe Bloggs
With this voice command (is not shown on the display) you can imme-
diately call a contact from your telephone book with active voice cont-
rol.
Note:
When doing so, it is important that the stated name exact-
ly corresponds with the entry stored in the phonebook.
Please note that telephone book entries, which are only
shown in capital letters must be spelt out.



Dialled calls
Missed calls
Received calls
Dial Joe Bloggs
Settings
All messages
New messages
Read messages
Dial sender
Read new message
Phone list
Clear list
Auto connect off
Auto connect on
Pin Code
Bluetooth
Accept
Additional help
Audio feedback
Voice Dial
Default