THB Bury Bluetooth Hands-Free Car Kit CC 9060 - Manual (Page 6)

8
Installation of the hands-free car kit
9
5. Connecting the Electronic box
Please connect the switch box AC 5120 to the electricity supply of the
radio and connect the Molex plug with the electronic box (see chapter:
Connection of the loud speaker switch box AC 5120).
Now connect the microphone (connection 5) and the plug of the moni-
tor (connection 6) to the electronic box.
Through connection 4 the hands free set passes on the voice of the
dialogue partner during the telephone call. You can connect a separate
loud speaker (BURY accessories) or the AC 5120 to this connection.
With the latter variation, you use the vehicle’s internal sound system for
a voice return.
Note:
If the DIN ISO plug of the AC 5120 does not fit in your
vehicle, numerous adapters are available from dealers.

6. Installation instructions for the fuses
1
2
3
4
5
6
7
Connection options:
1 Power supply
2 Aux Out
3 Port for Accessory
4 External loudspeaker
5 Mikrophone
6 Display
7 basePlate System 9
Please cut through the red, the black and the blue cable by means of a wire cutter or scissors. Now
insert the two endings of the red cable resulting from the cut into one of the binders, then close it. If
you hear two clicking noises, the clamp snapped in properly. Now insert one of the fuses and then
repeat the procedure with the other cables.
If you install the CC 9060 without the switchbox AC 5120 please stick to the following instructions
regarding the power supply safety.