Toro Timemaster 20199 - Manual (Page 16)

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours • Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Check the blade-stop system operation.
• Check the air cleaner and clean or replace it, if necessary.
• Check the cutting blades.
• Wash underneath the machine.
Every 25 hours • Charge the battery (electric-start model only).
Every 50 hours
• Change the engine oil.
• Service the blade-drive system.
Before storage
• Charge the battery (electric-start model only).
• Empty the fuel tank before repairs as directed and before annual storage.
Yearly
• Service the air filter; replace it more frequently in dusty operating conditions.
• Change the engine oil.
• Replace the blades or have them sharpened (more frequently if the blade edges
dull quickly).
• Check the spark plug; refer to the Engine Operator’s Manual.
• Refer to your Engine Operator’s Manual for additional maintenance procedures.
Important: Refer to the Engine Operator’s Manual for additional maintenance procedures.
Preparing for Maintenance
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark plug
(Figure 29).
G017520
1
Figure 29
1. Spark-plug wire
Important: Before tipping the mower to change
the oil or replace the blades, allow the fuel tank
to run dry through normal usage. If you must
tip the mower prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip
the mower onto its side so that the air filter is
up in the air.
WARNING
Tipping the machine may cause the fuel to leak.
Gasoline is flammable, explosive, and can cause
personal injury.
16