Replacing the fuse, Replacing the battery – Toro Timemaster 20199 User Manual

Page 19

Advertising
background image

Replacing the Fuse

Electric-start model only

If the battery does not charge or the engine does not
turn with the electric starter, the fuse may be blown;
replace it with a 40-amp plug-in type fuse.

Important: You cannot start the machine with
the electric starter or charge the battery unless a
working fuse is installed.

1. Open the sealed fuse holder and replace the fuse

(Figure 35).

1

g016487

Figure 35

1.

Fuse holder

2. Close the cover to the fuse holder, and ensure that it

is sealed tightly.

Replacing the Battery

Electric-start model only

Removing the Old Battery

1. Contact an Authorized Parts Dealer to obtain a

replacement battery.

2. Remove the belt cover; refer to step 1 of

Servicing the Blade-drive System (page 20).

3. Remove the rear-discharge plug.

4. Move the handle to the vertical position.

5. Remove the 4 small bolts that hold the rear-deflector

and handle-lock lever assembly in place.

6. Fold the handle all the way forward.

7. Remove the rear-deflector and handle-lock lever

assembly (Figure 36).

G017523

1

Figure 36

1.

Rear-deflector and handle-lock lever assembly

8. Remove the cover from the battery.

9. Disconnect the leads from the battery.

10. Remove and battery and recycle it.

Note: Recycle the battery according to your state
and local regulations.

Installing the New Battery

1. Clean the battery-holding area on the mower

housing.

2. Set the new battery in place on the mower housing.

3. Connect the leads to the new battery.

Note: Ensure that you connect the black (negative)
wire to the negative (-) terminal and the red (positive)
wire to the positive (+) terminal.

4. Install the cover onto the battery.

Note: Ensure that the cover fits properly over the
wiring harness.

5. Install the rear-deflector and handle-lock lever

assembly onto the machine.

6. Raise the handle to the vertical position.

7. Secure the shroud with the 4 small bolts that you

removed in step 5 of Removing the Old Battery.

8. Install the rear-discharge plug.

9. Return the handle to the operating position.

19

Advertising
This manual is related to the following products: