Telect DNI-1B - Manual (Page 14)

DNI-1B User Manual Installation
Issue A Rev 2 108891 Telect, Inc. 2-5
6. Repeat Steps 2–5 for the DCS OUT cables, connecting them to the
NE-1 OUT termination points.
7. Route the NE IN cables to the same side of the network bay as the
DCS IN cables and the NE OUT cables to the same side as the DCS
OUT cables. Tie-wrap the cables in place within the extender panel
cable management brackets.
8. Repeat steps 2–6 for the NE cables, connecting the NE IN cables to
the NE-2 IN termination points and the NE OUT cables to the NE-2
OUT termination points.
9. Identify circuits on the designation labels.