Telect DNI-1B - Manual (Page 19)

User Functions DNI-1B User Manual
4-2 Telect, Inc. 108891 Issue A Rev 2
3. Partially insert the second plug in the OUT and IN jacks of the ap-
propriate NE-1 circuit.
4. Simultaneously push both plugs fully into the jacks.
L
OOPBACK
To temporarily loop an NE or DCS OUT port to its IN port, fully insert a
Bantam looping plug into the jacks of the appropriate circuit.
M
ONITORING
You can monitor NE and DCS circuit outputs from the front of the DNI-1B
panel.
Fully insert a single Bantam patch-cord plug into the monitor jack of the
appropriate circuit. Insert the cord’s other plug into the test set you are us-
ing to monitor the circuit.
Side View of
DNI1-B Panel
OUT
IN
Signal Path
MON
Side View
of DNI1-B
To Test
Set