Tricity Bendix SG552D - Manual (Page 31)

31
Installation instructions
Important - safety
requirements
This appliance is suitable for installing on
gas I2ELL and I2E.
To install the appliance on gas supply of I2E
the hotplate injectors must be changed to
those supplied with the appliance.
INJECTOR MARKING
I2ELL
INJECTOR MARKING
I2E
RHF 074 070
RHR 106 096
LHF 106 096
LHR 133 119
Check that this model is suitable for the type
of supply available. This appliance must be
installed and or serviced by a competent
person in accordance with the local Gas
Safety/Electrical requirements.
This appliance must be
installed by a qualified
electrician / competent person.
Safety may be impaired if
installation is not carried out in
accordance with these
instructions.
Before connecting the appliance
make sure that the voltage of
your electricity supply is the
same as that indicated on the
rating plate. This is situated on
the lower front frame of the
appliance and can be seen upon
opening the door. Alternatively
the rating plate may also be
found on the back or top of
some models (where
applicable).
Do not alter the electrical
circuitry of this appliance.
Provision for ventilation
This appliance is not connected to a
combustion products evacuation device. It
shall be installed and connected in
accordance with the current installation
regulations. Particular attention shall be
given to the relevant requirements regarding
ventilation.
The room containing the appliance should
have an air supply in accordance with local
requirements. All rooms require an
openable window or equivalent and some
rooms will require a permanent vent as well.
For room volumes up to 5m 3 an air vent of
100cm 2 is required: for room volumes
between 5m 3 and 10m 3 an air vent of 50cm 2
is required. If the room has a door that
opens directly to the outside, no air vent is
required. For room volumes that exceed
11m 3 no air vent is required. If there are
other fuel burning appliances in the same
room, local requirements should be
consulted to determine the requisite air vent
requirements.
Prolonged intensive use of the appliance
may call for additional ventilation, for
example opening a window, or more
effective ventilation, for example increasing
the level of mechanical ventilation where
present.
Moving your appliance
You may damage some soft or badly fitted
floor coverings when you move the
appliance. The floor covering under the
appliance should be securely fixed so it does
not ruck up when you move the appliance
across it. Alternatively you could remove the
floor covering. This appliance is heavy and
care must be taken when moving it. Do not
try to move the appliance by pulling the door
handles.