Toro Sand Pro 5020 - Manual (Page 149)

Service and Repairs
Seat (SP 2020/3020)
1
5
3
4
2
9
10
11
2
4
6
12
7
8
6
13
14
15
16
Figure 5
1. Seat 7. Cap screw 12. Angle bracket
2. Cap screw 8. Seat clamp 13. Spacer
3. R–clamp 9. Service decal 14. Lock nut
4. Flat washer 10. Rubber cushion 15. Seat base shield
5. Manual tube 11. Seat plate 16. Cap screw
6. lock nut
Removal Installation
1. Park machine on a level surface, engage the park- 1. Install seat plate to frame by securing plate to angle
ing brake, lower attachment, and stop engine. brackets and seat clamps with cap screws, flat washers,
and lock nuts. Secure manual tube and R–clamps to
2. Lift seat up. Remove four cap screws from seat angle bracket with cap screws, flat washers, and lock
plate and seat. Separate seat from plate. Make sure not nuts.
to lose four spacers.
2. Position seat and spacers to seat plate. Insert cap
3. Remove seat plate from frame by removing lock screws through plate and spacers. Screw cap screws
nuts, cap screws and flat washers from the angle brack- into seat and tighten.
ets and seat clamps.
3. Replace rubber cushions if worn or damaged.
Whells, Brakes,
and Miscellaneous
Sand Pro 2020/3020/5020 Page 6 – 5 Wheels, Brakes,and Miscellaneous