Toro Sand Pro 5020 User Manual
Page 49
3. Tighten both set screws on the engine hub to secure
6. Install seat base with seat attached to the frame as
hub to the engine shaft (Fig. 46).
follows (Fig. 44):
4. Connect throttle control cable to the swivel and
choke control cable to the choke lever (see Throttle and
Choke Control Installation).
A. Position base on machine. Secure base to frame
with both spacers, cap screws, flat washers, and
lock nuts.
5.
Connect wire harness as follows (Fig. 45):
B. Secure seat rod to the base with flat washer and
cotter pin.
A. Connect blue wire to the magneto terminal.
7. Install and connect battery to the machine (see Bat-
B. Connect blue wire with fusible link to voltage reg-
tery Service in Chapter 5 – Electrical Systems).
ulator.
8. Secure fuel hose to the fuel pump with hose clamp.
C. Connect red/white wire to fuel solenoid.
Remove clamp from fuel hose that was used to prevent
fuel spillage. Open fuel shutoff valve.
Sand Pro 2020/3020/5020
Page 3 – 29
Engine
Engine