Toro Sand Pro 5020 - Manual (Page 55)

Towing Traction Unit
In case of emergency, the Sand Pro can be towed for a
short distance. However, Toro does not recommend this
as a standard procedure. IMPORTANT: Do not tow the machine faster than 2
to 3 mph because drive system may be damaged. If
machine must be moved a considerable distance,
transport it on a truck or trailer. Tires may lock up if
machine is towed too fast. If lock up occurs, stop
towing the machine. Wait for the traction circuit
pressure to stabilize before resuming towing at a
slower speed.
Check Hydraulic System Fluid
The hydraulic system is designed to operate on Mobil
424 hydraulic oil. The machine’s 3 gallon tank is filled at
the factory with oil. However, check oil level before the
engine is first started and daily thereafter.
1. Remove cap from the hydraulic oil tank.
2. Check oil level in the tank. Oil level should be up to
the top of the cone point on tank screen.
IMPORTANT: To prevent system contamination,
clean top of hydraulic oil containers before punctur-
ing. Assure pour spout and funnel are clean.
3. If fluid level is low, slowly fill tank with appropriate hy-
draulic fluid until level reaches bottom of screen. DO
NOT OVERFILL.
NOTE: The fluids within this group are interchange-
able.
Group 1 Hydraulic Fluid (Recommended for ambient
temperatures consistently below 100
o F.):
ISO type 46/68 anti–wear hydraulic fluid
Mobil
Amoc
International Harvester
Texaco
Shell
Union OIl
Chevron
BP Oil
Boron OIl
Exxon
Conoco
Kendall
Phillips
Mobil Fluid 424
Amoco 1000
Hy–Tran
TDH
Donax TD
Hydraulic/Tractor Fluid
Tractor Hydraulic Fluid
BP HYD TF
Eldoran UTH
Torque Fluid
Power–Tran 3
Hyken 052
HG Fluid
4. Install tank cap.
1
2
Figure 6
1. Cap 2. Tank (SP 2020/3020)
1
2
Figure 7
1. Cap 2. Tank (SP 5020)
Hydraulic Systems
Sand Pro 2020/3020/5020 Page 4 – 5 Hydraulic System (Rev. A)