Trango Broadband TrangoLINK-45TM - Manual (Page 17)

Getting Started System Information (sysinfo) Page
Trango Broadband Wireless — TrangoLINK-45 page 17
********************************* 5 *********************************
[Tx MIR] 50000 Kbps
[ARQ] on
[Encrypt] off [Key] 0011 2233 4455 6677 8899 AABB CCDD EEFF
[Auto Rate Shift] on
[Auto Scan MU] off
[RSSI LED] on
[Remarks] Remarks
********************************* 6 *********************************
[Eth Config] ANEG
[Eth Status] 100 FDX
[Eth In] 35,262,413 bytes 3 Kbps
[Eth Out] 9,201,047 bytes 51 Kbps
[RF In] 0 bytes 0 Kbps
[RF Out] 0 bytes 0 Kbps
[ARQ Retransmission] 0 pkts
Success.
#>
To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number.
Example:
#> sysinfo 2
********************************* 2 *********************************
[Radio Temp] 34 C [PoE Voltage] 14.2 V
[Opmode] on [Default Opmode] on
[Active Channel] 22 h [Freq] 5840 MHz
[Speed] 6 Mbps [Tx Power] 0 dBm [Power Range] -10..22 dBm
[Peer ID] DE6159FA [Status] disconnect [RSSI] n/a
[Peer IP Config] n/a
[DFS Status] idle
Success.
#>
Each of the parameters within the sysinfo screen is defined below
Section 0
[Model]
Radio Model # (P5055M)
[Unit Type] User defined Unit Type (MU or RU)
[Hardware Version] Hardware version set by factory (5010)
[Firmware Version] Current firmware version loaded in radio
[System Up Time] Time since last reboot or power cycle
Section 1
[MAC]
MAC address of radio