TP-Link TL-R402M - Manual (Page 27)

TL-R402M Cable/DSL Router User Guide
20
¾ WAN MAC Address - This field displays the current MAC address of the WAN port, which is
used for the WAN port. If your ISP requires that you register the MAC address, please enter
the correct MAC address into this field. The format for the MAC address is
XX-XX-XX-XX-XX-XX (X is any hexadecimal digit)
¾
Your PC's MAC Address - This field displays the MAC address of the PC that is managing
the router. If the MAC address is required, you can click the Clone MAC Address button
and this MAC address will fill in the WAN MAC Address field
¾
Click Restore Factory MAC to restore the MAC address of WAN port to the factory default
value
¾
Click the Save button to save your settings
)
Note:
1. Only the PC(s) on your LAN can use the MAC Address Clone feature.
2. If you click the Save button, the router will prompt you to reboot.
4.5 DHCP
Figure 4-10 the DHCP menu
There are three submenus under the DHCP menu (shown in Figure 4-10): DHCP Settings,
DHCP Clients List and Address Reservation. Click any of them, and you will be able to
configure the corresponding function. The detailed explanations for each submenu are provided
below.
4.5.1 DHCP Settings
The router is set up by default as a DHCP (Dynamic Host Configuration Protocol) server, which
provides the TCP/IP configuration for all the PCs that are connected to the router on the LAN. The
DHCP Server can be configured on the page (shown in Figure 4-11):
- DHCP
y DHCP settings
y DHCP Clients List