TP-Link TL-R402M - Manual (Page 44)

TL-R402M Cable/DSL Router User Guide
37
¾ Remote Management IP Address - This is the current address you will use when
accessing your router from the Internet. The default IP address is 0.0.0.0. It means this
function is disabled. To enable this function, change the default IP address to another IP
address as desired
To access the router, you will type your router's WAN IP address into your browser's address (in
IE) or Location (in Navigator) box, followed by a colon and the custom port number. For example,
if your Router's WAN address is 202.96.12.8 and you use port number 8080, enter in your
browser: http://202.96.12.8:8080. You will be asked for the router's password. After successfully
entering the password, you will be able to access the router's web-based utility.
)
Note:
Be sure to change the router's default password to a very secure password .
4.7.6 Ping from WAN
Figure 4-28 Ping from WAN
¾
Ignore Ping Packet from WAN Port - Enable or Disable ignore ping packet from WAN port.
If enabled, the ping packet from the Internet cannot access the router
4.8 Static Routing
A static route is a pre-determined path that network information must travel to reach a specific
host or network. To add or delete a route, work in the area under the Static Routing page (shown
in Figure 4-29).