TP-Link TL-R402M - Manual (Page 45)

TL-R402M Cable/DSL Router User Guide
38
Figure 4-29 Static Routing
To add static routing entries:
1. Enter the following data:
¾
Destination IP Address - The Destination IP Address is the address of the network or
host that you want to assign to a static route
¾
Subnet Mask - The Subnet Mask determines which portion of an IP address is the network
portion, and which portion is the host portion
¾
Gateway - This is the IP address of the gateway device that allows for contact between the
router and the network or host
2. Click the Enable checkbox.
3. Repeat steps 1-2 until you are finished.
4. If you are finished. Click the Save button to save it.
To modify an existing entry:
1. Modify the entry’s Destination IP Address, Subnet Mask and Gateway.
2. Click the Save button.
To delete an existing entry:
1. Select the entry as you desire and make all of its fields blank.
2. Click the Save button.
To delete all the entries:
1. Click the Clear All button.
2. Click the Save button.