Telex RadioCom BTR-500/600C - Manual (Page 10)

Initial Equipment Set-Up
Unpacking
Unpack your RadioCom System. A system package
should contain the following Items:
Contact the shipper or your dealer immediately if
anything is damaged or missing. Fill out the regis-
tration card and return it to Telex to properly regis-
ter your unit.
Antenna Information
Antenna Connection
The base station is supplied with two (2) antennas.
One 1/2-wave antenna for Transmit and one
1/2-wave for Receive. The antennas have TNC male
connectors.
The frequency range of the antennas should match
the receiver and transmitter of the base station.
Match the color code on the antenna with the color
code on the base station.
Attach the receive 1/2-wave antenna to the antenna
input receptacle labeled “Receive” on the right side
of the rear panel. The antenna should be vertically
aligned.
Figure 9
Attaching Receive 1/2-Wave Antenna
-7-
Quantity Descripton
1 BTR-500 or BTR-600C Base Station
1 TR-500 or TR-600C Beltpack
1 Wall Power Supply
2 Antennas (one Transmit and one Receive)
1 Interconnect Cable (9 pin to 9 pin)
2 Dummy Loads (3 pin XLR male)
1 Operating Instructions
1 Warranty and Registration Card
2 Plastic Screwdrivers
4 Rubber Feet