Telex RadioCom BTR-500/600C - Manual (Page 15)

RF Transmit Mode Switch
Allows the operator to select three different types of
transmitting modes; continuous transmit, transmitter
off, or remote transmitter. For most operations,
place the transmitter switch in the “CONT” position
(Continuous mode).
In the Continuous mode the RF transmitter will be
on at all times regardless of whether the portables
are on or not.
In the Remote mode, the only time the base can
transmit is when a portable unit is turned on.
In the Off mode the base station will not transmit to
the remote belt-packs. This mode might be used if
the base is to be an intercom system monitor station
only.
Figure 20
Transmit Switch
Intercom Type Switch
Set for Telex or RTS Type intercom systems.
Figure 21
Intercom Select Switch
Dual Listen Switches
These two switches allow the mixing of the inter-
com channels. The mixing of audio channels occurs
locally, only at the base station and its beltpack. The
switches do not affect the audio in the intercom
lines into the base station.
Figure 22
Dual Listen Switches
CH1 + 2 Switch = OFF
CH2 + 1 Switch = OFF
The two intercom audios are isolated. Audio chan-
nel one cannot be heard on channel two and vise
versa.
CH1 + 2 Switch = ON
CH2 + 1 Switch = OFF
Audio channel two will be mixed into audio channel
one. The volume of the mix of channel two as heard
in audio channel one may be controlled by the level
control.
CH1 + 2 Switch = OFF
CH2 + 1 Switch = ON
Audio channel one will be mixed into audio channel
two. The volume of the mix of channel one as heard
in audio channel two may be controlled by the level
control.
CH1 + 2 Switch = ON
CH2 + 1 Switch = ON
Both audio channels are mixed into one another.
The level of the other channel may be heard at the
volume set by the level control.
-12-
XMIT
REMOTE
MODE
CONT.
O
F
F
I/C
RTS TELEX
CH2 + 1
CH1 + 2
O
N
DUAL
LISTEN
LEVEL