TRENDnet TV-IP100-N User Manual
Page 11
10
1. Screw Hole
It located on the top/bottom panel of the camera. The screw hole
is used to connect the camera stand onto the camera by attaching
the screw head on the camera stand into the screw hole of the
camera.
2. Power LED
A steady
BLUE
light indicates that the Camera is powered on.
3. Link LED
A steady
ORANGE
light indicates that the camera has good
connection to LAN/WLAN. It begins flashing to indicate the
camera is receiving/sending data from/to the LAN/WLAN.
4. Power Connector
The DC power input connector is located on the back of Camera’s
rear panel, and is labeled DC5V with a single jack socket to
supply power to the Camera. Power will be generated when the
power supply is connected to a wall outlet.
5. Reset Button
Reset will be initiated when this button is pressed. Factory Reset
will be initiated when this button is pressed continuously for five
seconds.