TVS electronic MINI THERMAL RP-3180 - Manual (Page 13)

[Default]
If the horizontal length or vertical length is 0, this command is
canceled and the next data is handled as normal data.
If the horizontal start point + horizontal length is greater than
the horizontal printable area, the horizontal printable area -
horizontal start point is taken as the horizontal length.
If the vertical start point + vertical length is greater than the
vertical printable area, the ertical printable area vertical start
point
is taken as the vertical length.
Fractions resulting from calculations are corrected with the
minimum pitch of the mechanism, and the remainder are omitted.
The horizontal start point and horizontal length are calculated with
the basic calculation pitch (x). The vertical start point and vertical
length are calculated with the basic calculation pitch (y).
When the horizontal starting position , vertical starting position,
printing area width, and printing area height are defined as X, Y,
Dx,and Dy respectively, the printing area is set as shown in the
figure below.
This printable area for this printer is approximately 72.2 mm
{512/180"}in the horizontal direction and approximately 117.3 mm
{1662/360"} in the vertical direction.
XL = xH = y L = yH = 0
dxL = 0, dxH = 2, dyL = 126, dyH = 6
(X,Y)
Dx
Dy
(X+Dx-1,Y+Dy-1)
Paper Feed Direction Print area
ESC X n
[Name]
[Format]
[Range]
[Description]
Select character Double-width mode
ASCII ESC X n
Hex 1B 58 n
Decimal 27 88 n
1
n 8
Select character Double-width mode.
19
ESC d n
[Name]
[Format]
[Range]
[Description]
[Details]
[See Also]
Print and feed n lines
ASCII ESC d n
Hex 1B 64 n
Decimal 27 100 n
0
n 255
Prints the data in the print buffer and feeds n lines.
This command sets the print starting position to the beginning of
the line.
This command does not affect the line spacing set by ESC 2
or ESC 3.
The maximum paper feed amount is 1016 mm {40"}. If the paper
feed amount (n x line spacing) of more than 1016 mm {40"} is
specified, the printer feeds the paper only 1016 mm {40"}.
ESC 2, ESC 3
ESC I
[Name]
[Format]
[Description]
[Details]
Full cut
ASCII ESC i
Hex 1B 69
Decimal 27 105
Cut the paper fully.
During cutting, printing and paper feeding is stopped.
This command is valid only when an auto-cutter is connected.
ESC j n
[Name]
[Format]
[Range]
[Description]
[Details]
Print and feed paper
ASCII ESC j n
Hex 1B 6A n
Decimal 27 106 n
0
n 255
Prints the data in the print buffer and feed the paper [n x vertical or
horizontal motionunit].
After printing is completed, this command sets the print starting
position to the beginning of the line.
The paper feed amount set by this command does not affect the
values set by ESC 2 or ESC 3.
In standard mode, the printer uses the vertical motion unit (y).
The maximum line spacing is 1016mm {40"}. When the setting
value exceeds the maximum, it is converted to the maximum
automatically.
20 RP-3180 USER'S MANUAL RP-3180 USER'S MANUAL